Long Our Batteries Laptop Life
First post by: www.itsbattery.com
1. In the use of IBM 02K6928 Battery carefully read the user manual before the battery maintenance part of it;
2. When the first charge, you should continuously charge the battery to put 12 hours, and cycle to fully charge and discharge completely 3 times in order to awaken a new battery;
3. If the prolonged use of external power supply, it is best to remove the battery. A lot of friends did not take note of this problem, use an external power supply not remove the battery will not only affect the battery life, but also to allow laptop cooling burden becomes even heavier, shortening the life of laptop;
4. Periodic charge and discharge. Even without the memory effect of the lithium-ion battery There is a certain inertia effect, a long time not to use lithium-ion will lose their activity, required re-activation. Therefore, if a long time (three weeks or longer) do not use a computer or the IBM 02K6620 Battery charge and discharge found that shorter time, the battery should be fully discharged before recharging, the general of each month at least one complete charge and discharge times.
5. Recharged when best to switch off the laptop, the battery can completely full of electricity, do not unplug the power half-way in the charge. Shutdown charge than the boot more than 30% charge to shorten the charging time, and can extend the battery life. Best finish in 30 minutes after charging the use of.
6. To prevent exposure to prevent damp to prevent the chemical liquid erosion, avoid contact with the metal battery contacts, such as short-circuit happened happen. Lithium battery charge and discharge the number of generally not more than 800 times, each time electric charge, it would shorten the life span of the first. U.S. proposals to make full use of external power supply, if necessary several times to use half-way Plug Power, and the laptop does not pull out the built-in battery, IBM 02K7039 Battery let a lot because each time access to external power supply is equivalent to a battery charge.
For laptop users, we recommend the use of WindowsXP operating system, of course, if the laptop configuration is too low even WindowsXP can not meet the minimum dell latitude d620 battery, dell latitude d820 battery configuration requirements, it is another matter.
Have a lot of reasons, one of the main point is that the laptop power management for all computer operating systems are currently the most advanced, if the Centrino platform, coupled with so much the better. 1.6GHz of the Pentium-M smaller load only job in the following frequency of 600MHz. If your laptop to support the Intel SpeedStep dell inspiron e1505 battery, dell td347, AMD PowerNow or Transmeta’s LongRun technology, we must remember that loaded the latest drivers, to play its biggest utility, WindowsXP is automatic, you can request in accordance with their own performance and looking for power on a point of balance.
Users can make the most optimized power management IBM ThinkPad X60 Battery settings, 1. Do not use a screen saver.
2. The power scheme, select “Portable / Laptop”, following the time reasonably required in accordance with your settings, all of them for their circumstances vary, inconvenience dell inspiron 2600 battery, dell inspiron 2650 battery to make hard and fast rules. General put hard disk turn off set-up time was slightly longer than the standby time, so as not to affect the hard disk life.
3. To enter the “Power Options” property of “advanced”, the rational use of “power button”, give you a great deal of convenience, can also enhance the rational use of battery capacity. For instance: put “in the closed portable computer” is set to “standby”, which left the laptop at a moment when both the power but also on the confidentiality of dell 1g222, dell bat3151l8 personal information are very helpful, but do not need to wait to restart time. For the use of first-line maker of laptop (such as IBM, SONY, HP, Toshiba, etc.), usually to provide some better power IBM FRU 92P1167 Battery management software, and has some special features: IBM’s power management procedures can reduce the LCD screen refresh rate; TOSHIBA Toshiba’s power management can be inadequate in the electricity directly turn off your equipment at any one of the specified; SONY dedicated power management process can set the fan speed, can also turn off non-use of the IEEE1394 interface as well as the MEMORY STICK slot, so as to achieve the goal of dell laptop battery energy saving.
In the use of laptop - hp laptop battery, we can achieve energy saving hardware has the following main categories: 1. To reduce laptop LCD screen brightness, LCD liquid crystal screen laptop in power consumption are large, we can reduce the screen brightness to the appropriate reduce its consumption of electricity, the majority of laptop through the “Fn” + “F8″ or “F9″ to adjust the screen brightness, typically have eight kinds of brightness options, the general choice between brightness almost a key to look your personal hobby .
2. Laptop will be designed taking into account the expansion IBM ThinkPad Z60t Battery of capacity to facilitate connections with other hp f4098a, hp f4809a, hp f4812a devices. So we will see around the laptop has a lot of peripherals can be connected to expand the mouth, as long as the layout of a reasonable extension of the mouth are of course more to expand the capacity of the stronger. However, power consumption per port are required, excessive external interface on the increase of unnecessary power consumption and shorten battery life capacity. Laptop’s LPT, serial most people rarely used, it is recommended in the BIOS will disable them. If your laptop has infrared features, when not put it off, which in the “Device Manager” directly to disable it, then open when required.
3. Now almost all the computer compaq presario 2100 battery has a built-in Modem and network card, it is best put them to turn off the opening when required. Have a lot of computer with a wireless card, if you temporarily do not have access to, it is recommended to disable, otherwise it is in constant search of the network, the consumption of unnecessary power consumption.
4. Energy saving hard disk. Laptop compaq presario 2500 battery maximize the memory capacity to improve performance, reduce power consumption hard drive constantly reading, memory, if reached 512MB, using the Windows XP system, you can disable the virtual memory to avoid frequent hard disk to read.
5. Some of the Laptop BIOS Medium CPU will adjust the IBM ThinkPad Z61t Battery energy-saving technologies, such as parts of the state, to examine the function is turned on.

How to correctly use reasonable battery
First post by: www.itsbattery.com
Now a lot of IBM Laptop Battery with a lithium-ion batteries, lithium-ion batteries and memory performance but did not have a strong inertia, the need to activate red power about 12 hours, but now the manufacturers have to do at the factory prior to the activation treatment, so a new battery in previous general said that the first three red electric adjustment period will not need 12 hours to buy batteries or salespersons will tell us when the three previous 12-hour hub that is a wrong!
That was before the red nickel series battery power time. The right time is 4 - 6 hours, and preferably the battery off after use to their own re-red that is a natural discharge, over a period of adjustment after the red is red after a good more red for half an hour is about two and a half hours on ok, the battery generally has to go through about 10 times the cycle of red discharge in order to achieve the best results! 2128 series of battery power of previous red standby after a comparatively short time is normal, after 10 times around the circle of red discharge can reach more ideal standby time, and is generally about four days. The first three red 4 - 6 hours, after each two half-hour red on ok
Now more popular the three previous Laptop Battery charge has two arguments:
1. Is to buy the time machine, so that red more than 12 hours
2. The second is filled with more red after 1-2 hours for the best
The first one is the nickel-metal hydride battery-ibm thinkpad t60 battery, Chong Law, in the past are nickel-metal hydride batteries, due to nickel-hydrogen batteries have memory, so it is best spent the previous three and then red, red 12 hours, let the battery fully activated to achieve the best effect, this is a practice, so say those who are accustomed to selling, but now has changed.
Lithium salt is not necessary so long time. Lithium has inertia, however small, in the factory has been pre-activated, so the new battery has been part of the electricity, this inertia is not a long time after three charge can be resolved, and in the future with the process of , it will be nice and slowly, using the IBM 02K7054 Battery to activate the battery itself is also a kind of behavior, and memory capacity of lithium is very small, so do not need to discharge, exhausted after each red, red power attention should be paid when the voltage should be stable, so as to achieve the best effect. Lithium has overshoot protection, beginning with high-current charge, after a trickle charge, full of power automatically, and then the effect is not red, and red may be more cause heavy discharge cycle, the time longer may have caused damage to the battery. The first three are like this, then you can with the red with the use, and recommendations are used up and then red, you can extend the battery life. After the charging is full after about an hour and more red on it. Not recommended for frequent recharging, as is the life of lithium and its recharging has relations, the general life of lithium power capacity in accordance with its size and different, but basically are 300-700 times, so frequent red discharge affect the battery life on the charger is bad.
The battery can be a circle of red discharge around 500, 2128 series of battery after a few red discharge cycle can be achieved after the standby time of around four days, then the operator can click on the 3 years, 3 years after 2128 have been eliminated, Therefore, use of a battery! Battery life is measured by the number of red discharge, if the IBM ThinkPad A20 Battery has not run out on the red will shorten battery life, the general current lithium-ion battery life is the red discharge about 500 times. It is proposed that try to run out of battery power and then red.
If users want to prolong the battery’s- thinkpad t60 battery, effective use of time, apart from the quality of the charger must be guaranteed, the right skills is also essential to charge, because the poor quality of the charger or charging the wrong methods will have an impact on battery life and cycle life The following is the charging techniques:
1. Battery factory, manufacturers have been activated to deal with, and carried out a pre-charge, so the battery has more than electricity, has a friend that the battery charge in accordance with the time period of adjustment, standby is still an acute shortage, assuming the battery is indeed genuine, then the IBM ThinkPad A20M Battery, in which case adjustment period should be extended another 3 ~ 5 times fully charge and discharge.
2. If the new purchase is a lithium-ion battery, then 3 ~ 5 times before the charge commonly referred to as an adjustment period, should allow for more than 14 hours to ensure full activation of lithium-ion activity. Lithium-ion battery without memory effect, but has a strong inert, should be given to fully activated, can guarantee the future use to achieve the best performance.
3. Some automated intelligent rapid charger when the lights change directions, they only express full of 90%. Charger will automatically slow to change with full charge the battery. It would be preferable to use the battery is full, otherwise they will shorten the time.
4. Before charging, lithium batteries-lenovo thinkpad t60 battery, do not need special discharge, discharge improper battery will damage. Charging as much as possible in order to slow to reduce the fast charge mode; time not more than 24 hours. After three to five times the IBM ThinkPad A21M Battery fully charge and discharge cycles of its internal chemicals will be all the “activation” to achieve the best results.
5. Please use the original or the reputation of a good brand chargers, lithium batteries use lithium battery charger dedicated, and follow the instructions, otherwise they will damage the battery, and even dangerous.
6. Often have many users in the charge was to open, in fact, such a life would be very easy to hurt, because in the process of charging, the circuit boards will be fever, at this time if there are external phone, you may have an instant return current, parts of internal damage.
7. Battery life determined by the number of repeated thinkpad t60 battery, charge-discharge, it should be avoided as far as possible when more than a rechargeable battery, which will shorten the battery life. Shutdown time for more than seven days, the first battery should be fully discharged, adequate electricity and then use.
8. Battery self-discharge exist, not a day when the nickel-hydrogen batteries remaining capacity will be about 1% of discharge, lithium batteries a day by 0.2% ~ 0.3% discharge. To charge the battery as far as possible, using a dedicated outlet, the charger should not be shared with television sets, home appliances outlet.
9. Although the network coverage area-IBM ThinkPad R60 Battery, but in the off charge, it is already unacceptable and call the. At this point, you can use non-pass transfer function, will be transferred to the side of the fixed phone in order to prevent the loss of calls, this method is not in network coverage area or weak signals were temporarily unable to get through when they apply.
10. Do not expose the battery under high temperature or cold, such as dog day weather, should not be placed on the car, stood in the scorching sun exposure; or get air-conditioned rooms, the place direct blowing of air-conditioned place. When charging, the battery is normal to have a little hot, but it should not high temperature “suffering.” In order to avoid this from happening, it is best carried out at room temperature for charging, and not covered in anything.
11. Ni-Cd (N iCd) must be guaranteed before the battery completely dead battery, rechargeable IBM ThinkPad T60 Battery after the need to ensure adequate power.
12. If the battery is placed but not been used too long, it is best to apply for the maintenance department to deal with batteries for a living, you can own a DC barostat, adjust voltage of 5 ~ 6V, current 500 ~ 600mA reverse battery- ibm thinkpad t60 battery, connection. Note that touch open up to repeat three times, after such treatment, the re-use original charger to carry out “period of adjustment” charge.
13. The longer the charging time is not good, for there is no protection circuit full battery charge should be stopped immediately, otherwise the battery overheating due to heat or impact performance.
14. Lithium-ion battery charger must be selected precincts, or may fall short of saturation, affect its performance. After charging, should be placed in the charger to avoid the more than 12 hours or more, long-term need not be the IBM 40Y6797 Battery and separation.